Somfy programming

How to set up multiple blinds for the five channel Somfy remote control. Har du mistet bruksanvisningen til ditt Somfy -produkt? Her kan du raskt laste ned bruksanvisning gratis. Bring the shade to desired upper limit stop point.

Stop) and until the motor moves, then release. If the shade stops when the buttons are released take it back to the upper limit and repeat) Stop the motor when reaching the desired lower limit.

You can adjust by pressing or. For programming instructions please go to page 69. Completely plug and play, no electrician required. A previously programmed remote can be used in order to add a new remote or channel to the Motorized Window Covering.

If a Telis Transmitter has not been previously programme please refer to the installation instructions of the relevant RTS motorized window covering. To delete all previous settings: Using a paperclip, press and hold the PROGRAM. BUTTON located at the side of the motor for approximately seconds, during which the motor will jog separate times.

All remotes and limits will be erased ( motor is now reset to factory mode).

Motor limits will need to be reestablished. This video will provide step-by-step instructions for the initial myLink setup. On some occasions it may be necessary to either add a new . Your browser does not currently recognize any of the video formats available.

Click here to visit our frequently asked questions about HTMLvideo. An error occurred while retrieving sharing information. DECOFLEX WIREFREE RTS SWITCH. PROGRAMMING – ADDING A DECOFLEX RTS WALL SWITCH – INITIAL INSTALLATION.

DecoFlex Channel (white). Place the RTS receiver into the programming mode. Recording the RTS controller: Press the button to the rear of the handset for approximatley secon the blind will shunt once when the controller is recorde (see notes below). Erasing the memory of the RTS receiver: Press the program button for.

STEP 3: To erase the back release position, set it on the hard stop limit. Setting Intermediate Preferred My Position: Glydea 60e RTS Only. Recording MY favorite position: To set the my STOP) position, move the drapery to the desired intermediate position.

Programming the RTS control point. It is recommended to power only the motor being programmed ( disconnect power to all the other motors).

Motor will exit programming mode after minutes . Now that they are installe you review the instructions and get ready to program their shades. Despite your thorough preparation, you are still secretly hoping everything goes smoothly. AC, radio operated motors are identical in their programming , but require a slightly different proceedure for factory reset.

Instructions for installing the blinds themselves are available on the product page. The motor head of the WireFree Roll Up incorporates a program button and a port for the battery pack cable. The program button is used to reset the motor to factory mode or to pair additional remote controllers. Control the motor and check the correct direction of rotation.

Reverse the direction of . Please Read and Follow These Instructions. The remote control instructions can be used for reference and they are not as accurate . Read honest and unbiased product reviews from our users.